Page 1 of 1
extruder move itself ( printer Delta G2S )
Posted: Thu Dec 17, 2015 4:28 am
by elric_romain
Hello,
Sorry for my English.
I configured the printer as the tutorial shows.
I calibrate the printer with the Home key to Repetier.
All is ok but the 3 axes ( X, Y and Z ) move by itself after a few minutes.
the stepper motors do not take the extruder.
Can you help me please ?
Best regards.
Romain.
Re: extruder move itself ( printer Delta G2S )
Posted: Thu Dec 17, 2015 2:39 pm
by Mark
the extruder motor will not turn until the temperature reaches above 170 degrees, so have you checked this?
And here's a link to check the extruder problems:
http://www.geeetech.com/forum/viewtopic ... 13&t=17097
Re: extruder move itself ( printer Delta G2S )
Posted: Thu Dec 17, 2015 3:00 pm
by elric_romain
No, the extruder motor is Ok.
it's the 3 motors that move the entire 'extruded'
without touching Repetier, they move alone in a minute or two
the extruder moves down 1 or 2 cm
Re: extruder move itself ( printer Delta G2S )
Posted: Thu Dec 17, 2015 3:51 pm
by Mark
oh sorry my bad. this is normal, the motor will disable themselves after 2-3mins, you if this happens during the calibration, you can move the Z axis around to keep it busy now and then...
Re: extruder move itself ( printer Delta G2S )
Posted: Thu Dec 17, 2015 11:11 pm
by elric_romain
Ok, thanks for this information.
Can we keep the 3 motors available all the time ?
May be an option box in Repetier software ?
Romain.
Re: extruder move itself ( printer Delta G2S )
Posted: Fri Dec 18, 2015 4:41 pm
by Mark
you can try this: add "M84 S0" behind any command in the scripts, and every time after you home the printer, click the script to move it to the position, then it won't fall down again.
(you can change the command to the 3 coordinates when doing calibration)
- QQ截图20151218162848.jpg (92.1 KiB) Viewed 12763 times
- QQ截图20151218163221.jpg (228.08 KiB) Viewed 12763 times
And remember to uncheck the option below:
- 20160216112059.jpg (167.04 KiB) Viewed 12354 times
also add a "M84 S0" here:
- QQ截图20160216113040.jpg (181.52 KiB) Viewed 12354 times
Re: extruder move itself ( printer Delta G2S )
Posted: Sun Dec 20, 2015 12:38 am
by elric_romain
Hello Mark,
I will try this weekend.
Is is also the firmware has changed ?
Romain.
Re: extruder move itself ( printer Delta G2S )
Posted: Tue Dec 22, 2015 5:13 pm
by Mark
it will not affect the firmware, just some shortcuts.