Page 1 of 1
Motor axis direction during Auto Home Command
Posted: Sun Nov 15, 2015 2:55 pm
by flipdave
Which direction should each drive move during the Auto Home command? My Y drive moves the bed aft towards the Y limit switch, the X drive moves the extruter left, away from the X axis limit switch, and the Z drive moves the extruter down towards the bed.
Re: Motor axis direction during Auto Home Command
Posted: Mon Nov 16, 2015 3:34 pm
by Sherry
flipdave wrote:Which direction should each drive move during the Auto Home command? My Y drive moves the bed aft towards the Y limit switch, the X drive moves the extruter left, away from the X axis limit switch, and the Z drive moves the extruter down towards the bed.
all of axis should go toward their endstops.it seems that your x axis direction are reversed.you can change it's direction in the firmware.
Re: Motor axis direction during Auto Home Command
Posted: Tue Nov 17, 2015 2:32 am
by flipdave
Thanks Eric, where do I find that latest file for the Prusa I3 with I think it's the GT 2560 board
Re: Motor axis direction during Auto Home Command
Posted: Tue Nov 17, 2015 3:03 am
by flipdave
Never mind , I found the file!
Thanks
Re: Motor axis direction during Auto Home Command
Posted: Tue Nov 17, 2015 3:59 am
by flipdave
Never mind , I found the file!
Thanks