Geeetech

Hi I have a sanguinololu rev-1.3 board and a Prusa I3 in Aluminum printer.

The Z step motors don’t seem to have sufficient power to move the extruder. But when the step motors are not connected to the rods, they function properly. And I can turn the motors easily by hand when the power is off. Everything seems to run smoothly mechanically.

Can someone tell me how to increase the power to the step motors?

Thank you

http://www.geeetech.com/forum/viewtopic ... 13&t=17038
refer to the link here, it will help you I think.

Thanks, it all works perfectly.
Just a small regarding noise. Should i bring the power down to the step motors?

you can try it. My Z axis is 0.9V, works well.