Geeetech

To all Delta users,

I have a new G2S and still in the initial setup but I am having issues with the manual controls. I have noticed that movements in certain directions such as left on X-axis,up on Y-axis, and down on Z-axis when doing steps of ten are moving steps of ten. But as I move the machine to the right on X-axis, down on Y-axis, and up on Z-axis that it is only moving one step when I give it a command of ten steps. This is quite a big issues as I can not calibrate the machine. I have been searching the code to find some errors but with no luck. If anyone else has had this issue and have a resolution for such a problem, please let me know.

Thanks.

Sorry, I don't have an answer for you, but I have the same problem on the Delta Rostock Mini G2.

How about 50 steps? Are they conduct like this again?

The movements are not constant. Sometimes the 50 it will move 50, other times it does not move 60.