Page 1 of 1
Motors moving only to home
Posted: Tue Jul 07, 2015 9:12 pm
by 1inv
Board RUMBA with DRV8825 for printer Leapfrog Creatr.
All axises goes only to home (do not move + / - ) in manual control.
What must I do?
Re: Motors moving only to home
Posted: Wed Jul 08, 2015 10:22 am
by Admin
Could you take a photo of LCD.i 'd like to see what LCD shows.
Re: Motors moving only to home
Posted: Wed Jul 08, 2015 10:51 am
by Sherry
hi,do LCD panel display any error such as MINTEMP error or MAXTEMP error?please do the following steps.
1.Click "emergency stop" in the repetier-host.
2.Reconnect the wire to controlboard.please plug the wire to into the slot firmly.
3.Restart the printer.
Re: Motors moving only to home
Posted: Wed Jul 08, 2015 3:51 pm
by 1inv
My printer does not have an LCD display. Currently, board removed from the printer. I'm trying to run it, just by connecting the stepper motor and mechanical endstop.