Page 1 of 3
Extruder motor not turning !
Posted: Fri Jun 12, 2015 10:56 am
by zuzumba123
Extruded motor not turning , the motor works I tested it in other area , but when I plug it in extruder after hits 200 temperature , still does not work ... I need help
do all how in
http://www.geeetech.com/forum/viewtopic ... 17&t=16485 . need firmware i think
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:05 am
by zhangxueyou
Let's check if the extruder motor driver is fine.
Turn off the printer, swap extruder motor driver with x or y motor driver, turn on the printer , Move x and y to center, let the axes auto home, check if all the axes move fine.
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:09 am
by zuzumba123
i check it and it is fine...
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:14 am
by zhangxueyou
Let's check if it is firmware issue. What is your printer type and mainboard type? We will send the correct firmware to your email.
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:14 am
by zuzumba123
extruder motor driver is fine i check it!
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:16 am
by zuzumba123
geeetech i3. GT2560. He writes that it is "Ultimaker"
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:17 am
by zuzumba123
geeetech i3. GT2560. He writes that it is "Ultimaker"
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:30 am
by zuzumba123
how can install firmware (repetier host or )?
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:35 am
by zhangxueyou
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 11:52 am
by zuzumba123
i updated gt2560 but still not work