Page 1 of 3
axis problem
Posted: Sat May 02, 2015 9:16 pm
by kaiser1
hi i got a prusa i3 geeetech 3d printer. I already assembled it and connected to my pc with repetier host but when i try to move manually the axis x y z they don't do my command and sometimes the axis wont stop even if they reach the limit.
Re: axis problem
Posted: Mon May 04, 2015 10:30 am
by zhangxueyou
Is there any error displayed on computer when you try to move them?
Please let all the axes auto home first, then check if you can move them separately.
Re: axis problem
Posted: Tue May 05, 2015 4:00 pm
by kaiser1
there is no error on repetier host when i move them. When i move them sometimes for example i day +10x but the y axis moves too. I can use the home buttom but i cant move z and y moves just in 1 direction. Which configuration.h there is in the sanguinololu rev 1.3a?
Re: axis problem
Posted: Tue May 05, 2015 4:07 pm
by zhangxueyou
How do you connect the endstops? Can you take some pictures?
Re: axis problem
Posted: Wed May 06, 2015 8:56 pm
by kaiser1
this is how i attached my end stop
Re: axis problem
Posted: Wed May 06, 2015 8:56 pm
by kaiser1
this is how i attached my end stop
Re: axis problem
Posted: Thu May 07, 2015 10:16 am
by zhangxueyou
Please take more pictures, let me see the color of wires connected to enstops switches.
- QQ截图20150416103734.png (678.36 KiB) Viewed 11770 times
Re: axis problem
Posted: Mon May 11, 2015 2:00 am
by kaiser1
Re: axis problem
Posted: Mon May 11, 2015 2:15 am
by kaiser1
when i click +10mm x in repetier host it moves both axis x and y
Re: axis problem
Posted: Mon May 11, 2015 9:12 am
by zhangxueyou
The endstops are connected correctly.
How about controlling the motors on LCD?
