None of my stepper motors are moving.
Posted: Sun Apr 19, 2015 2:04 am
Ok, just as some other people on here are having problems my none of my stepper motors will move. I have gone over the wiring and everything is in order. I'm assuming I need to load firmware and am not sure where to begin as I am new to all of this. Any help would be appreciated. Thanks.
I have the i3 pro B model with sanguinololu board and A4988 drivers.
The heatbed and extruder both heat just fine, the only thing that isn't working are the motors, they make no sound or anything.
I have the i3 pro B model with sanguinololu board and A4988 drivers.
The heatbed and extruder both heat just fine, the only thing that isn't working are the motors, they make no sound or anything.