Hello
( sorry for my bad english ) i'm french
I'm a new user with a me creator 2 printer
I have a problem to print with her
All my print have a decalage
First problem : when i moove Y axe he stuck you can see here
https://youtu.be/9cv40R6_S60
2nd problem : i update firmware and the printer still won't print in the center
Same after i try this Navigate to Y0 X10 Z0 and reset home offset
Problem Y axe
Re: Problem Y axe
Hi,
You can check if there is some deformation on your Y axis(the shell,the bearings on the rods and the rods).
And try moving the Y motor after turning the printer off to check if you can move it smoothfully.
You can check if there is some deformation on your Y axis(the shell,the bearings on the rods and the rods).
And try moving the Y motor after turning the printer off to check if you can move it smoothfully.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!