x axis problem

[omaarben12]

Hi so i have a geeetech prusa i3 aluminium printer and it's working but i have a problem when i press the home button in repetier or with the lcd secren it works without any problem but when i move only the X axis (the one with the extruder) it only move in one way and the other 2 axis works normal and i swapped the Y axis cable that goes to the board with the X axis now the X axis work and the Y dosen' work

thank you

[William]

Hi so i have a geeetech prusa i3 aluminium printer and it's working but i have a problem when i press the home button in repetier or with the lcd secren it works without any problem but when i move only the X axis (the one with the extruder) it only move in one way and the other 2 axis works normal and i swapped the Y axis cable that goes to the board with the X axis now the X axis work and the Y dosen' work

thank you

Hi,
Did you have a right connection to your motherboard on every motor?And were the status of X/Y/Z endstop normal.
See if the following article will help you:
http://www.geeetech.com/forum/viewtopic ... 18&t=17883