Y axis stepper motor issue

Post Reply
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Y axis stepper motor issue

Post by Mark » Fri Aug 07, 2015 2:52 pm

Did you swap the driver board? what's the result?
Top
Zolt@n
Posts: 13
Joined: Tue Jun 23, 2015 4:51 pm

Re: Y axis stepper motor issue

Post by Zolt@n » Fri Aug 07, 2015 10:57 pm

I swapped the Y axis connector(stepper motor connector) with the X axis connector on the driver board and now the X axis is the one acting up. So I can conclude that the PCB board is not working correctly. Maybe a firmware update could fix?
Top
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Y axis stepper motor issue

Post by Mark » Sat Aug 08, 2015 11:30 am

I've sent the firmware to you and you can find out .If the problem still happens,plz contact the customer service .
Top
Post Reply

Return to “Stepper Motor”