the GNB x-motor is 0.9 v now after i fixed it. it was 0.12 v.
I can move the x-motor with ease.
The PSU is at 21.3 V after i turn the power down from 24,8 V. the problem is that I can't turn it down any more.
Wrong cable input in the PSU?
x-axis onley goes to the left
-
3Dmarketse
- Posts: 10
- Joined: Sat May 23, 2015 10:00 pm
Re: x-axis onley goes to the left
i Tested all the GND and the last one over the x motor input made sparks......
-
3Dmarketse
- Posts: 10
- Joined: Sat May 23, 2015 10:00 pm
Re: x-axis onley goes to the left
i found the answer to why it doesn't work.
the X- Stepper Driver Module conduct no electricity.
I Changed places with the Y-Stepper Driver Module and the X-Stepper Driver Module and the x started gave 0.9 V and the Y 0.9 V.
the X- Stepper Driver Module conduct no electricity.
I Changed places with the Y-Stepper Driver Module and the X-Stepper Driver Module and the x started gave 0.9 V and the Y 0.9 V.