X Y Z axis for those new to 3d printing

Post Reply
szeiger
Posts: 40
Joined: Sat Mar 14, 2015 11:10 pm

Tips and tricks website

Post by szeiger » Wed Mar 25, 2015 9:20 pm

Found this site while looking for some answers: reprapsquad.wordpress.com
Worth checking out
Top
szeiger
Posts: 40
Joined: Sat Mar 14, 2015 11:10 pm

X Y Z axis for those new to 3d printing

Post by szeiger » Thu Mar 26, 2015 1:29 am

Most of the problems I have had were related to not having X and Y configured correctly. If you are having trouble with the stop switches and homing, make sure X, the carriage that moves left and right, and Y, the hotbed/glass are plugged into the correct spots on the Sang board, with the X being towards the front of the printer, and then Y, Z, and then extruder.

Hope this helps someone.

Scott
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: X Y Z axis for those new to 3d printing

Post by zhangxueyou » Thu Mar 26, 2015 9:28 am

Thank you for sharing.
Top
Post Reply

Return to “Stepper Motor”