Printing problem on the aluminum prusa i3
Posted: Wed Sep 13, 2017 8:24 am
So finally I've tried my first print the end result is a barely finished spagetti mess.
I stated the print and everything seemed fine the place filament coming out of the nosle and all seemed fine until I noticed the filament came out very wavy/curly and all over making the farthest thing from a clean line the second problem being that the filament stopped coming out of the nosle about a minute into a 10 minute print.
I don't know if I bought a kit with a broken extruder or im just retarded I'm not sure.
I stated the print and everything seemed fine the place filament coming out of the nosle and all seemed fine until I noticed the filament came out very wavy/curly and all over making the farthest thing from a clean line the second problem being that the filament stopped coming out of the nosle about a minute into a 10 minute print.
I don't know if I bought a kit with a broken extruder or im just retarded I'm not sure.