Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

Mixing/Multi extruder for the A10T.

http://geeetech.net/forum/viewtopic.php?f=120&t=71025

Page 1 of 1

Mixing/Multi extruder for the A10T.

Posted: Tue Aug 04, 2020 10:11 am
by IamAnubis
Hi,

So after finding out how to perform some of my own maintenance after having many issues with my A10T and its firmware, I have found Vert(abreak) online and discovered how to flash over new firmware.

After doing some investigation I am just perfecting the firmware and I need to know if the A10T is a 3 in one virtual stepper or a 3 in 1 physical stepper.

Any assistance would be great.

Re: Mixing/Multi extruder for the A10T.

Posted: Fri Sep 11, 2020 9:54 pm
by Gilgawrath
Similar problem.

I'm trying to sort out the "configuration.h" file but sure what to change/ remove to make it correct specifically for the A10T v2.0 and would appreciate any help.

Re: Mixing/Multi extruder for the A10T.

Posted: Fri Oct 02, 2020 2:02 am
by Przepka1985
IamAnubis wrote: ↑
Tue Aug 04, 2020 10:11 am
 Hi,

So after finding out how to perform some of my own maintenance after having many issues with my A10T and its firmware, I have found Vert(abreak) online and discovered how to flash over new firmware.

After doing some investigation I am just perfecting the firmware and I need to know if the A10T is a 3 in one virtual stepper or a 3 in 1 physical stepper.

Any assistance would be great.
On Vert Firmvare you dont need to change anything in mixing area :) Go to StartHere.h and uncoment #GTA10T config file wil compile suitable mix for you. You using this for custom printer.
Anyway you got 3 stepers and one virtual
on Cura I got 8 virtual steppers for mixing, also known as vtool from marlin2
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/