Page 1 of 1
Guide on proper filament replacement
Posted: Wed Jun 10, 2020 6:34 pm
by eddyuk
Hi,
Is there a guide on how to properly remove filament and insert filament on 3 nozziles? I always endup unclogging the hotend in the way I do it so wonder if I do it wrong.
Re: Guide on proper filament replacement
Posted: Thu Jun 11, 2020 9:16 am
by William
Re: Guide on proper filament replacement
Posted: Thu Jun 11, 2020 3:22 pm
by eddyuk
Thanks for answer, but it is cleaning procedure. I am actually referring to guide on loading and unloading filament.
Re: Guide on proper filament replacement
Posted: Fri Jun 12, 2020 10:41 am
by William
Hi，it is recommended that you try to clean the hot end every time you run out
Re: Guide on proper filament replacement
Posted: Wed Jun 17, 2020 7:04 am
by Barmac
William
There has to be a better way.
You can't really expect people to do that every time they change filament.
How about switching to Teflon tubing?
Re: Guide on proper filament replacement
Posted: Wed Jun 17, 2020 9:39 am
by William
You can let the three extruders discharge before printing, and then start printing.
Our white tubes are made of Teflon, make sure they are inserted at the bottom