color management
Posted: Wed Jan 06, 2021 2:58 am
Hello,
I'm new in 3D printing, anyway, I have very good experience with A20T.
Anyway, I face an issue with color management.
I use CURA to generate Gcode file.
In any case, I can only print with 33%/33%/33% color mix. Even if I desactivate the 2 other extruders in Cura, result is same. I although tried to modify mix through printer panel during printing....no resultt.
Is anybody able to help me in solving this trouble?
Thank you in advance.
Olivier.
I'm new in 3D printing, anyway, I have very good experience with A20T.
Anyway, I face an issue with color management.
I use CURA to generate Gcode file.
In any case, I can only print with 33%/33%/33% color mix. Even if I desactivate the 2 other extruders in Cura, result is same. I although tried to modify mix through printer panel during printing....no resultt.
Is anybody able to help me in solving this trouble?
Thank you in advance.
Olivier.