Geeetech

Bonsoir,
J'ai essayer de brancher un bl-touch. J'ai surement fait un mauvais raccordement. Je l'ai démonté.
Maintenant, lorsque je fait un auto home, l'axe Y ne bouge plus. L'axe X va à gauche, L'axe Z remonte de 2 ou 3 mm à la place de descendre.
Merci d'avance pour vos réponces.

Google translation:
Good evening,
I try to connect a bl-touch. I probably made a bad connection. I took it apart.
Now, when I make an auto home, the Y axis does not move anymore. The X axis goes to the left, The Z axis goes up 2 or 3 mm instead of going down.
Thank you in advance for your responses.

Hi,if you remove the automatic sensor, you need to update the firmware to the original firmware.

Thank you,
I am not a specialist.
What do you mean "sensor"? (the bl-touch?)

Hi,yes your bltouch.

Hi,
I make all what you tell me, but not result. I can't moving Y axes, and when i put autohome, X go but up, not down, if i put again auto home, x up again and Y don't move again.
You thinking it's my mother board is broken?
If yes, Where I can buy a new one?
I leaving in belgium (Liège) I don't know if have a professional can coming here for repair that. I m Handicap, I cazn't easy moving.
Thanks

Hi, You can try to see if your probe is demagnetized,
You can try to remagnetize it,
Touch the probe with your finger to see if it can retract properly.

Hi,
Can you tell me where i can buy a original motherboard gt2560 v4.0.
I scary cause have too much different.
You have a direct line for buy it?
Thank's

Hi,You can buy through geeetech official website
or contact your sales for related consultation.