The TMC2208 about A20T Firmware

[Admin]

Hi,Guys.

the firmware about the A20T TMC2208

you can download from this link :

A20T_TMC2208.rar

(121.39 KiB) Downloaded 1316 times

[giogio]

HI i need same for A30T please

have you the uncompiled firmware please?

thanks

[William]

Hi, thanks for your feedback.
now the firmware is being tested.

[mlabis]

Hi friends, is there A20T firmware with 3D touch and TMC2208 support?

[William]

Hi friends, is there A20T firmware with 3D touch and TMC2208 support?

Hi，we do not have the corresponding firmware, you can directly exchange the wire sequence as shown in the figure.

M%FVH~(1HA}5Q`}S%Y7P$KL.png (302.93 KiB) Viewed 26944 times

[Bobertino]

I would like to upgrade to TMC2208, but have BlTouch.

Are you saying that if we swap the wires it will be supported?

Do you know when we will have a firmware with TMC2208 and 3DTouch support?

[William]

Hi，the firmware has nothing to do with the driver, you can still use the firmware that supports 3Dtouch.

[Bobertino]

I have installed TMC2209 https://www.amazon.co.uk/dp/B082FBLH62/ ... _at_prodpg

I'm trying to tune the VREF and all I get is 4.88v. Potentiometer makes no difference on output.

I know it could be a defective product, but I would be surprised if 5 of them are defective.

Any suggestions on what might be the problem?

[William]

Hi，can't adjust the voltage?

[Bobertino]

Correct. I can't adjust the voltage.

My guess is that the VREF pin hasn't been wired correctly, I found someone else with the same problem.

They probably work fine, but I have no way to adjust them without the VREF pin working.

I'm going to return them and get a different brand.