A20T Firmware with BL-Touch

[MaSt52]

Where can I get the firmware for my A20T with BL-Touch from? Best in .hex

[William]

Hi,T series firmware with 3dtouch is currently being tested, thank you for your feedback.

[MaSt52]

Hello Vert, thanks for the hint and the link, unfortunately I have a problem creating the .hex file. My Marlin IDE always throws an error message.

"exit status 1
Fehler beim Kompilieren für das Board Arduino Mega or Mega 2560."

My printer is an A20T with feeder upgrade to Bowden MK8 aluminum, 3D touch.

[MaSt52]

I watched the video and followed the instructions as much as possible, unfortunately I also cannot compile with the "Visial Studio Code" software, which is still unknown.

error message:

Erstellen und Debuggen nicht möglich, da die aktive Datei keine C- oder C++-Quelldatei ist.
(Cannot build and debug because the active file is not a C or C ++ source file.)

[andrevanderweide]

did you load the extensions in visual studio code: auto marling build and platformIO ide

[MaSt52]

Yes I have, unfortunately it just doesn't work for me.


I would be very grateful if someone could send me the .hex file

Standard A20T with upgrade to 3 x aluminum feeder (i need to invert the direktion) and 3D touch

[MaSt52]

can I create the .hex file in any other way, with visual studio code it just doesn't work

[MaSt52]

it finally worked, thanks for the effort and thanks for the work

[xardomain]

Do you mind sharing the hex file or at least the configuration files used to get the firmware working?
Thanks.

Giuseppe Marullo