printing stopped at 97 to 98 % before end of process

[alfvv12]

hi.

i use cura 4.9.1. and geeetech A20m.

the prints are stopped shortly befor the print is completed. mostly 97 to 98 finished.....

i found no solution...

any idea??

thx

[Admin]

Hello, are you printing a multi-color model? If so, the temperature of the extruder may be too low during the refueling process, causing cooling. You can increase the temperature to prevent printing failure.
Or the problem with the TF card, you can try to print online, or replace the Tf card.

[runyon13]

hi.

i use cura 4.9.1. and geeetech A20m.

the prints are stopped shortly befor the print is completed. mostly 97 to 98 finished.....

i found no solution...

any idea??TelltheBell

thx

Since they have a thermal cutoff, your extruder will stop working in the middle of your print if the temperature gets too high. The only way to resolve this issue is to turn off the printer and allow the electronics to cool down. To avoid the problem completely try adding an extra cooling fan.