G20M 3D Printer Issue
Posted: Mon Jun 28, 2021 3:39 pm
Hello,
Before 3 weeks I have purchased a very popular A20M 3D Geeetech printer which comes with a touch sensor. I have also set up it very well according to the manual instructions. I have followed all the manual guide instructions during installation but it did not work. I assembled it correctly and check the installation twice. The main issue is that when I started it the first time for print the printing head getting jam into the build plate continuously, So I tried to resolve it But can't stop get it completely. So I put a lot of pressure on the printer head. After that, I again start printing but the print can't reach the build plate. This issue is of 3 weeks and still I not get my money refund. So What I supposed to do with this trouble? Even if I remove the sensor could I downgrade again & get the correct offset? OR is there anything else going wrong with this My A20M printer? Please anybody from here can help me to resolve this problem?
Greetings.ome tv omegletv
Before 3 weeks I have purchased a very popular A20M 3D Geeetech printer which comes with a touch sensor. I have also set up it very well according to the manual instructions. I have followed all the manual guide instructions during installation but it did not work. I assembled it correctly and check the installation twice. The main issue is that when I started it the first time for print the printing head getting jam into the build plate continuously, So I tried to resolve it But can't stop get it completely. So I put a lot of pressure on the printer head. After that, I again start printing but the print can't reach the build plate. This issue is of 3 weeks and still I not get my money refund. So What I supposed to do with this trouble? Even if I remove the sensor could I downgrade again & get the correct offset? OR is there anything else going wrong with this My A20M printer? Please anybody from here can help me to resolve this problem?
Greetings.ome tv omegletv