Page 1 of 1
Anyone using the new MK8 extruders with the A20M?
Posted: Thu Oct 22, 2020 3:50 pm
by ElmerLeonard
Hi,
Has anyone used the new MK8 extruders with the A20M? They can be foudn listed here:
https://www.geeetech.com/new-mk8-extrud ... -1132.html
Are they better than the crappy Titan clones on the current A20M that constantly keep jamming up?
Thanks.
Re: Anyone using the new MK8 extruders with the A20M?
Posted: Tue Oct 12, 2021 4:33 pm
by mohan31
https://www-192-168-100-1.com/
https://192-168-l0-1.club
https://192-168-l-10.com/192-168-l-l
Thanks for the best blog. it was very useful for me.keep sharing such ideas in the future as well.
Re: Anyone using the new MK8 extruders with the A20M?
Posted: Sat Jan 08, 2022 10:10 pm
by mohan31
https://192-168-l-l.us/10-10-0-1-piso-wifi/
https://192-168-l-l.us
Thanks for sharing. I found a lot of interesting information here. A really good post, very thankful and hopeful that you will write many more posts like this one.
Re: Anyone using the new MK8 extruders with the A20M?
Posted: Sat Apr 23, 2022 4:19 pm
by mohan31
https://www-10-0-0-1.com/
10.0.0.1 is a default IP Address that is used by the Netgear and D-Link model routers. This router gateway is a private IPv4 network. There is only one device that can be used on this IP address.
http://router-tech.com