Geeetech

Hi all,

Question:

I installed a new SUPERPLATE on my A20M.
No problem but something strange happend.
After I replaced the endstop and leveling the bed I started a new print.
the print started but the nozzle was hovering above the superplate!!
the filament was dropping on the plate
Someone with the same problem?

I need a solution for this, anyone?
is it something I have to change in the firmware?
And how do I do that?
I never made changes in Firmware so I need some help with that...

Cheers in advance.

Hi!
Maybe the reason you installed 3d Touch? Reinstall 3d touch and try again?

William wrote: ↑

Mon Aug 17, 2020 3:17 pm

Hi!
Maybe the reason you installed 3d Touch? Reinstall 3d touch and try again?

Cheers But I already fixed it