Question about A20M fan placement?
Posted: Tue Jul 07, 2020 10:29 pm
Hello,
I'm new to 3D printing. Recently, I had a problem with the hotend so I replaced it. But I don't take care about the 2 fans placements. Since, my printer often pause printing without error message. I just have to select "Resume" to continue but it's a little bit annoying for long prints.
I suspect I mount the 2 fans in a wrong way. omegle xender Actually, the 2 fans take the air from outside to the hotend.
Could you confirm the direction of the air flow ? (I wonder if left fan take air to the hotend and the right to outside, but not sure).
I'm new to 3D printing. Recently, I had a problem with the hotend so I replaced it. But I don't take care about the 2 fans placements. Since, my printer often pause printing without error message. I just have to select "Resume" to continue but it's a little bit annoying for long prints.
I suspect I mount the 2 fans in a wrong way. omegle xender Actually, the 2 fans take the air from outside to the hotend.
Could you confirm the direction of the air flow ? (I wonder if left fan take air to the hotend and the right to outside, but not sure).