A20M firmware update (GT2560 V4)
Posted: Fri Jun 19, 2020 11:51 pm
Hi all after successfully replacing my motherboard
i tried to flash it and it work
but after i see that on serial monitor
any idea what mean :
i can heat up the bed by sending gcode
i can't move XYZ by sending gcode
?
i tried to flash it and it work
but after i see that on serial monitor
Code: Select all
Marlin 1.1.8
echo: Last Updated: 2017-12-25 12:00 | Author: (none, default config)
echo:Compiled: Aug 18 2019
echo: Free Memory: 2490 PlannerBufferBytes: 1360
echo:V402open stored settings retrieved (614 bytes; crc 14630)
echo:poweroff stored settings retrieved (56 bytes; crc 0)
read file dir:
read file name:
echo: G21 ; Units in mm
echo: M149 C ; Units in Celsius
echo:Filament settings: Disabled
echo: M200 D1.75
echo: M200 D0
echo:Steps per unit:
echo: M92 X80.30 Y80.80 Z400.00 E395.00
echo:Maximum feedrates (units/s):
echo: M203 X300.00 Y300.00 Z20.00 E25.00
echo:Maximum Acceleration (units/s2):
echo: M201 X3000 Y3000 Z50 E3000
echo:Acceleration (units/s2): P<print_accel> R<retract_accel> T<travel_accel>
echo: M204 P1000.00 R2000.00 T1000.00
echo:Advanced: S<min_feedrate> T<min_travel_feedrate> B<min_segment_time_us> X<max_xy_jerk> Z<max_z_jerk> E<max_e_jerk>
echo: M205 S0.00 T0.00 B20000 X20.00 Y20.00 Z0.40 E5.00
echo:Material heatup parameters:
echo: M145 S0 H190 B60 F0
echo: M145 S1 H240 B90 F0
echo:PID settings:
echo: M301 P45.80 I3.61 D145.39
echo: M304 P182.46 I35.92 D231.70
hardware version:0.00
Fixed parameter bytes; crc error 39375
Fixed parameter nbytes; crc error 65535echo:SD init fail
- Fixed parameter bytes; crc error 39375
Fixed parameter nbytes; crc error 65535echo:SD init fail
i can heat up the bed by sending gcode
i can't move XYZ by sending gcode
?