Replaced Extruders on A20M. Need to adjust steps/mm
Posted: Sun May 10, 2020 4:31 am
HI there.
I did not follow the advice, and I bought two MK8 Extruder Aluminum feeder Kit for 1.75mm filament for my A20M.
I installed them and they are running just fine, but I had to change steps/mm from 395 to 93 because it was overextruding a lot. Prints now are kind of ok (If you have any other adjustements idea let me know. I just changed steps/mm, not speed).
But now, everytime I switch off the printer, I need to change from 395 to 93 on the know, It wont't stay changed on the printer memory.
Any ideas how can I "save" that parameter on the printer?
I did not follow the advice, and I bought two MK8 Extruder Aluminum feeder Kit for 1.75mm filament for my A20M.
I installed them and they are running just fine, but I had to change steps/mm from 395 to 93 because it was overextruding a lot. Prints now are kind of ok (If you have any other adjustements idea let me know. I just changed steps/mm, not speed).
But now, everytime I switch off the printer, I need to change from 395 to 93 on the know, It wont't stay changed on the printer memory.
Any ideas how can I "save" that parameter on the printer?
