Replaced Extruders on A20M. Need to adjust steps/mm

[delir6]

HI there.
I did not follow the advice, and I bought two MK8 Extruder Aluminum feeder Kit for 1.75mm filament for my A20M.
I installed them and they are running just fine, but I had to change steps/mm from 395 to 93 because it was overextruding a lot. Prints now are kind of ok (If you have any other adjustements idea let me know. I just changed steps/mm, not speed).

But now, everytime I switch off the printer, I need to change from 395 to 93 on the know, It wont't stay changed on the printer memory.

Any ideas how can I "save" that parameter on the printer?

[delir6]

Ok, I found the option on the menu to Store Settings.
Happy user again