Geeetech

Posted: **Thu Apr 09, 2020 8:51 pm**

Just when I thought I was finally going to get to use the printer the heated bed has failed. When will this madness stop. I need to know the voltages that I should see on the pins when the heat should be heating up. Also, does anyone have the resistance values you should see on these points? I have attached a picture of the points I am interested in. Thank you collectively for your support. Hopsing

: HeatBedConnector.jpg (421.4 KiB) Viewed 8207 times

Posted: **Fri Apr 10, 2020 9:25 am**

Hi, You can measure the resistance of the blue-green line.

Posted: **Sun Apr 12, 2020 12:14 am**

Does anyone know what resistances you should view on this connector?

Posted: **Sun Apr 12, 2020 12:16 am**

I only can read 5.0 volts to the pins on this connector. What should be the voltage to these pins?

Geeetech

Another setback - Now the bed heater has quit.

Another setback - Now the bed heater has quit.

Re: Another setback - Now the bed heater has quit.

Re: Another setback - Now the bed heater has quit.

Re: Another setback - Now the bed heater has quit.