Geeetech

Hello Team A20M.

I use all colors of the geetech filament for my A20M. But I don't have the settings for S3D, like temperatures, feed data, mm and mm/sec.
Can anyone hero? Thanks already!

Hi,If you use PLA consumables, the hot bed is stable at about 60 and the hot end temperature is about 210. If it is black consumables, the hot end is stable and appropriately reduced by 5-10. The reference range of printing speed is 30-60mm / s.
I hope this can help you.

Thanks William. Diese Daten habe ich angewendet. Warum bei dunklem Material andere Settings?
I have applied these data. Why different settings for dark material?