Page 1 of 1
Filament change
Posted: Thu Jan 02, 2020 6:41 pm
by thebakker
I have a geeetech a20m, but the menu has only the option to change the first filament.
I have this version installed (A20M_Marlin-1.1.x12864.zip)
Is there no option to change the second filament?
Re: Filament change
Posted: Fri Jan 03, 2020 9:28 am
by William
Hi,You can view your menu
Whether it is A20M firmware.
Re: Filament change
Posted: Sat Jan 11, 2020 2:16 am
by thebakker
Yes it says A20M.
When I set the mixer to 100:0 I can unload filament 1 and when to 0:100 I can unload filament 2,
But isn't there a option in the filament changer to select what filament to change?
Re: Filament change
Posted: Mon Jan 13, 2020 4:13 am
by chc
thebakker wrote: ↑Sat Jan 11, 2020 2:16 am
Yes it says A20M.
When I set the mixer to 100:0 I can unload filament 1 and when to 0:100 I can unload filament 2,
But isn't there a option in the filament changer to select what filament to change?
Hello,
This is the only solution I know. No other option.
Chinese Manufacturer's are not Champion in UI.
Best regards
Christophe