Geeetech

Hello,
I begin with printer.
I have intalled my printer and I print the dog test fine
I install curra and I configure it with resources find in this forum
I try to print yoda
https://cults3d.com/fr/mod%C3%A8le-3d/a ... 3d-designs
I stop the print because I see that a part of the piece is broken (see the picture)
Some body can explain me whats happen?
The temperature are not OK? I keep the default value....(200)

Hi, You can check if your nozzle is clogged,
You can try to heat the temperature to 200 and then manually push the consumables,
Clean it up in a timely manner if it is blocked;

Printing speed reference range: 30-60mm / s;
The print temperature is set to consistent.