Geeetech

Hello,

I have a simple question for the 3D touch sensor :

Did the correction be stored automaticaly after an auto-levelling? Or do we have to store the settings manualy? Or do we have to do the correction every time we switch on the printer?

Thanks in advance

Hi, After you calibrate your 3d touch, you need to save your changes.
You can refer to this: https://www.youtube.com/watch?v=_RtsZDbR2po

And after an auto levelling?

dbelge wrote: ↑

Fri Dec 13, 2019 6:34 pm

And after an auto levelling?

Hi,If your 3dtouch can be used normally, it can be printed normally.