Page 1 of 1
Print Not Sticking To Bed
Posted: Sun Oct 27, 2019 7:50 pm
by Chad Harvey
The print is not sticking to the bed. New A20M, set setting following the manu forum. The bed is leveled accordingly. As it extrudes sometimes the filament sticks to the bed, sometimes not causing. Anyone got recommendations on how to fix. What are best starting setting for speed, heat of bed, nozzle, etc?
Re: Print Not Sticking To Bed
Posted: Mon Oct 28, 2019 9:19 am
by William
Hi, you can try to level the hotbed.
Try increasing the bed temperature of the hotbed by 5-10°.
Re: Print Not Sticking To Bed
Posted: Wed Oct 30, 2019 7:13 am
by Jarda3d
Post a photo what it means that not sticking on the bed...
Superplate begin 103, then 110 (or 110 both if you want to wait 7-10 mins more)
PEI sheet 110 both.