Geeetech

=> i am trench

Actually, print stopped because the lcd message is (look picture)
==>> TEMP IS TOO LOW....

After this message, the hothend cooldown ans print is stopped...

Do you have hello for me ?

Hi，You can check if your hot end thermistor is fully connected.
If fully accessible, try measuring the thermistor at the hot end.

Hi,
If thermistor disconnect, the message is différent (i have testing)

Hi,If the hot-end thermistor is not connected to the screen and the display temperature should be -14°,
you can try to measure the thermistor at the hot end.

how to measure at the end? when I dismounted, the temperature given by the probe is equal to that of the temperature of the piece and when I put it in the fingers, it goes up ... apparently it reacts correctly ...

Use a multimeter to measure the thermistor resistance at the hot end,
I am not very clear what you mean, can you provide a specific video?
So that we can solve the problem better.

Eric,

Does this happens when you start printing or later during the print?

Yvon

hello sorry for the delay.
this happens near the end of the print. In the meantime, I changed the heating cartridge, but it is still the same

it always happen, even on small prints?

Can you check your gcode to see if there is no unwanted "stop heating" code before the end?

The same problem comes to me and I am still trying to fix it but couldn’t solve it. if you find the solution to this problem with mba custom paper writing service reviews then let us know because I am trying to find it and nothing happening and I want it.