Geeetech

Posted: **Tue Jul 23, 2019 7:46 pm**

Hi,
Just received my new A20M and the result is amazing compared to my previous geetech printer which was already awesome...
The printing sticks very well on the bed. Too well. Indeed, it is very hard to remove it. Even after cooling.

Do you have any tips ?

Posted: **Wed Jul 24, 2019 9:36 am**

Hi, You can try to heat the hot bed to about 60° and use a shovel to shovel the model down.

Posted: **Wed Jul 24, 2019 3:09 pm**

Hi, this is what I do :-s
Basically, it depends of the model. If the model has nice points to grab it, it is OK. But if it is flat, it is very difficult...

Posted: **Wed Jul 24, 2019 3:14 pm**

Hi， You can wait for the model to cool down and then use a shovel to carefully shovel it down.

Posted: **Sun Jul 28, 2019 3:49 am**

I use a knife.

Geeetech

Print very hard to remove from bed

Print very hard to remove from bed

Re: Print very hard to remove from bed

Re: Print very hard to remove from bed

Re: Print very hard to remove from bed

Re: Print very hard to remove from bed