Page 1 of 1
A20m "heating done"
Posted: Mon May 13, 2019 3:10 pm
by steve rebeyrol
Hello
I buy 2 A20M and sometimes the print stops with the message "heating done". do you know where it comes from? thank you
Re: A20m "heating done"
Posted: Mon May 13, 2019 3:15 pm
by William
Hi, How to display the temperature above LCD？
you can measure the resistance of the thermistor on the motherboard and the resistance of the hotbed.
Re: A20m "heating done"
Posted: Mon May 13, 2019 3:50 pm
by steve rebeyrol
The temperatures on the LCD are like when the printer is switched on: the order of the nozzle and the heating plate are at 0 but I can see the temperature. There is just the message below "heating done" instead of "A20M ready".
Okay but start measuring and I have to look for what?
thank you
Re: A20m "heating done"
Posted: Mon May 13, 2019 4:01 pm
by William
Hi, you can measure whether the power supply output voltage reaches the rated voltage; then check if the wiring is intact and the wiring may be poorly connected or damaged. The resistance of the heating cartridge is about 3.6ohms
Re: A20m "heating done"
Posted: Mon May 13, 2019 4:44 pm
by steve rebeyrol
ok thanks I look this and I open a new post because other problems arrived.
thanks