Geeetech

Hey everyone out there,

i was using Cura all the time but i found out that printing with Simplify the prints are more easy in a very good quality and on Cura it have a lot of problems with that dual extrusion.

So this is why im askin if anyone of u got an option to import that printer into Simplify. Best would be with 2 regular and 3 virtual extruders. (25/75, 50/50, 75/25)

Can anyone please help me ?

thanks

Hi,

i recieved my A20M just today and played a little around, i got the same idea as you, so i put the profile together.
Haven't tried it yet, Feedback is well appreciated!

https://www.thingiverse.com/thing:3596863

Best Regards

Hallo,
Ich plage mich im Moment auch mit den Simplify-Einstellungen für meinen A20M herum. Könntet Ihr mir Eure jetzigen Einstellungen zur Verfügung stellen?
Danke sehr!