This is a good mount because it mounts out back and leaves cooling scheme options open.
http://www.thingiverse.com/thing:1822188
Cool mount but I have not made 3Dtouch work yet
I spent four days and gave up for now. Taking a break. I am now very familiar with Configuration.h, Configuration.adv.h, pins.h. I have tried MARLIN'S RC & RC7 and the versions that you posted of course with appropriate changes for my system. I have a good working Geeetech Prusa i3 A pro-- in a wood and acrylic box.
resources
antclabs tutorial, Wiki, Geeetech here(same as wiki)
youtube, and more
If someone has 3Dtouch working on a Geeetech Prusa i3 A pro please help me. Post your configuration, pins,h and or pins.xxx.h configuration.adv.h and whatever else you change. For servo control I use the original Z min plug socket for ground and signal to servo plus I soldered a small wire underneath to the pos. (3.3V) there. Way easier than soldering 3 wires on top! The two wire plug goes to Zmax plug --D32 pin remapped to Zprobe-rremapped from Zmax , right?