Filament clog up

[ktown1900]

I have a Problem with my a20m.
Sorry for my Bad English.

When I print a big stl (>10h) with only one colour there is often the Problem that my second colour clog up.
I cant use it again and have to clean the extruder first.

Is there any Chance to avoid this?

Thank you

[William]

I think you should clean the hotend and replace the PTFE tube.
Then it should work normally.(But you need to confirm your slice setting is correct)

[ktown1900]

Where can i find the correct slice settings?

[William]

Print speed no more than 80mm/s for the A20M.
Temp setting(PLA):
1.Nozzle:180~210C，You need to set the all the nozzle temp to the same temp
2.Heat bed: 50~70C
Then you need to set the retarct to :
1.Retract distance:6.5mm
2.Retract speed:40mm/s

Then you need to check the extruder temp.
If it overheat then it will cause the filament soft then clogged.