I am using the A20M with Cura and making STL files with Blender and when I go to print, the top surface is very blochy and has holes in it. This seems to be a new issue and I have tried using different settings in Cura but they all have the same results. When I first got the A20 I was using the Ender-3 profile and had decent result but would not do dual filament.
Any suggestions would help. Thank you.
Incomplete upper surface
Re: Incomplete upper surface
Try my profile, you can use it without changes but hotbed is smaller as A10M have it.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.