Hello
I’m very new in 3D printers’s world!
I bought geeetech A20M and superplate, but when I try to set it up the extruder goes too deep. I look around and I found that the problem is set the Z axis through firmware update, but i’m not able to do that. Can anyone help me?
I use cura for Mac as slicer.
Help with super plate
Re: Help with super plate
Hi，ou need to upload the firmware via Arduino IDE 1.8.5
viewtopic ... 20&t=17046
viewtopic ... 20&t=17181
Hope to help you.
viewtopic ... 20&t=17046
viewtopic ... 20&t=17181
Hope to help you.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!