- HeatBedConnector.jpg (421.4 KiB) Viewed 8209 times
Another setback - Now the bed heater has quit.
Another setback - Now the bed heater has quit.
Just when I thought I was finally going to get to use the printer the heated bed has failed. When will this madness stop. I need to know the voltages that I should see on the pins when the heat should be heating up. Also, does anyone have the resistance values you should see on these points? I have attached a picture of the points I am interested in. Thank you collectively for your support. Hopsing
Re: Another setback - Now the bed heater has quit.
Hi, You can measure the resistance of the blue-green line.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Another setback - Now the bed heater has quit.
Does anyone know what resistances you should view on this connector?
Re: Another setback - Now the bed heater has quit.
I only can read 5.0 volts to the pins on this connector. What should be the voltage to these pins?