hello all,
Do you use the Geetech's provided link to download the Marlin firmware?
I did, and checked a bit and saw that the # extruder was enabled for 1, and the singlenozzle is not active/defined.
did you had to enable and work on the firmware a lot?
if there is a stable version of the firmware that needs only certain settings that needs the end user to find out (eg. PID), I am greatly tahnksful for your guidance as to where this is located.
thanks you in advance.
A20M: Marlin firmware Config.h Extruders
Re: A20M: Marlin firmware Config.h Extruders
Hi, If you want to modify the PID settings,
you can refer to this:https://reprap.org/wiki/PID_Tuning
I hope this can help you.
you can refer to this:https://reprap.org/wiki/PID_Tuning
I hope this can help you.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
![Smile :)](./images/smilies/icon_e_smile.gif)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: A20M: Marlin firmware Config.h Extruders
thanks William,
I know how to get the PID....
it is the FW reliability and to know if as a new user, it needs a tons of tinkering in the FW or not.
and weather there is an updated FW with the right setting to start from....![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
I know how to get the PID....
it is the FW reliability and to know if as a new user, it needs a tons of tinkering in the FW or not.
and weather there is an updated FW with the right setting to start from....
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
Re: A20M: Marlin firmware Config.h Extruders
never mind...
after spending 6 hours on the net and this forum, found the work from "Vert: admin", with youtube video and the // define read the document error... lol
now it is more in clear that the 2-1 extruder/singlenozzle can use virtual SW and physical Cyclon setting in the firmware to command the print.
Thank you Vert for your time for putting things to ease other's life!!!!
![Laughing :lol:](./images/smilies/icon_lol.gif)
after spending 6 hours on the net and this forum, found the work from "Vert: admin", with youtube video and the // define read the document error... lol
now it is more in clear that the 2-1 extruder/singlenozzle can use virtual SW and physical Cyclon setting in the firmware to command the print.
Thank you Vert for your time for putting things to ease other's life!!!!