Geeetech A20 Pinout?
Posted: Mon May 16, 2022 6:59 pm
Has anyone installed Klipper on the Geeetech A20 (non MMU)? I tried google searches and the klipper repo but only found the generic 2560 example.
The example pins don't seem to match the A20's definitions, so I'm yet to have a working config for it.
I've successfully setup Klipper on an Ender 3 before, so I'm not a total noob at least.
My google skills also failed to find a pinout diagram for the A20's 2560 board.
I'd really appreciate it if anyone has any info. Thank you
The example pins don't seem to match the A20's definitions, so I'm yet to have a working config for it.
I've successfully setup Klipper on an Ender 3 before, so I'm not a total noob at least.
My google skills also failed to find a pinout diagram for the A20's 2560 board.
I'd really appreciate it if anyone has any info. Thank you