Page 1 of 1
Configuration.h for Geeetech Prusa I3 Pro B
Posted: Sat Feb 13, 2016 7:10 am
by jburke4
Hello,
Can I get a copy of a working Configuration.h for a Geeetech Prusa I3 Pro B?
burkej4@live.com
Re: Configuration.h for Geeetech Prusa I3 Pro B
Posted: Sat Feb 13, 2016 11:54 am
by Sherry
Re: Configuration.h for Geeetech Prusa I3 Pro B
Posted: Sat Feb 13, 2016 12:48 pm
by jburke4
I have the firmware I was just looking for a Configuration.h that was already setup for that particular printer.
Re: Configuration.h for Geeetech Prusa I3 Pro B
Posted: Sat Feb 13, 2016 12:52 pm
by jburke4
I'm new to all of this so I wanted to compare my config file to someone who knows what they are doing.
Re: Configuration.h for Geeetech Prusa I3 Pro B
Posted: Sun Feb 14, 2016 7:06 am
by jburke4
Was calibrating my printer, went into the configuration.h and changed my x axis settings to hopefully make it more accurate. I uploaded it to my printer and boom, now I'm getting an heat Error.
Error: Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
The LED display claims that my hotend temperature is 481 degrees, however it is cold to the touch.
Re: Configuration.h for Geeetech Prusa I3 Pro B
Posted: Tue Feb 16, 2016 9:55 pm
by Mark
seems to be the Max temp error, what are the settings you change? how about use the original firmware?
And the temp error, check this link:
http://www.geeetech.com/forum/viewtopic ... 23&t=17030