Geeetech

So I have seen a lot of posts about prints stuck to the bed and problems getting them off. I only use PETG and have since the beginning because I did research before I got my printer and felt it was the best filament to use. So I'm not sure if this would work with other filaments but that's up to yo...

I use a washcloth to get things off the bed of the printer. I wet it then wring out as much moisture as I can and stick it in the freezer for a few minutes. I leave it in there long enough to get cold but not freeze up. I then drape it over my print and cover it and try to touch as much of the area ...

Got the problem fixed and currently running my 1st post problem print. Print is 75% done and no problems as of yet (knocks on wood).

I have recently gotten a A20 that I bought on amazon. I'm fairly new to 3D printing but I have friends and family that have been doing it for years that I can lean on for advice. I had growing pains and no success for the first 3 days. I changed the nozzle and it was clogged. The new nozzle enabled ...