Thankas for the info. I was suspecting min board or power supply. Tried settiing the warm up/cool down from the printers controls and I can't repeat the problem.
I will keep an eye on it for now.
Search found 4 matches
- Sun Nov 07, 2021 6:16 pm
- Forum: Geeetech A10 Series
- Topic: Temperature fluctuates on Nozzle and Bed
- Replies: 3
- Views: 2896
- Thu Nov 04, 2021 3:59 am
- Forum: Geeetech A10 Series
- Topic: Temperature fluctuates on Nozzle and Bed
- Replies: 3
- Views: 2896
Temperature fluctuates on Nozzle and Bed
Hello,
For a while now I have had an unsteady temperatuire on my nozzle, but did not know what it was. Today I caught the temperature of the nozle and bed dip during warm up. Does anyone have an idea of what is going on?
Duck
For a while now I have had an unsteady temperatuire on my nozzle, but did not know what it was. Today I caught the temperature of the nozle and bed dip during warm up. Does anyone have an idea of what is going on?
Duck
- Temp_on_Warmup.jpg (131.5 KiB) Viewed 2896 times
- Sat Jan 16, 2021 7:55 pm
- Forum: Geeetech A10 Series
- Topic: temperature problem
- Replies: 14
- Views: 18441
Re: temperature problem
Hi All, I am having exactly the same problem. After suffering under extrusion I narrowed wit down to nozzle the temperature being lower than its stetting/reading. I have used a IR thermometer to measure the temperature of the head/nozzle from a range of 50 to 250 degrees C. The profile printer repor...
- Fri Jan 15, 2021 8:10 am
- Forum: Geeetech A10 Series
- Topic: a10 print quality decrease
- Replies: 1
- Views: 2952
Re: a10 print quality decrease
Hello, I am having exactly the same issue. With prints I know to work having no strength. I had the printer at Christmas and now the print is poor. I believe the lroblem s under extrusion (not enough plastic) my prints weighed 30% lighter than they should. Try a different fillament ifbyou have it at...