Search found 1 match
- Sun Sep 27, 2020 6:24 pm
- Forum: Extruder
- Topic: hotbed/extruder is not heated up(GT2560/GTM32/sanguinololu)
- Replies: 37
- Views: 155110
Re: hotbed/extruder is not heated up(GT2560/GTM32/sanguinololu)
Hey printer-folks, I've got a similar problem that the heater was not heating up despite the fact that MOSFET, fuse, LEDs etc. all were OK. There were no 12V on the pins of the hot-end heater while the bed was working fine. When unmounting the board (GT2560) I discovered this: heater-pin.jpg Re-sold...