Geeetech

Hi, I have never done this forum thing before but here I go. I have an A10M that has been sitting for maybe over a year now. I expected there was going to be issues "waking it up" so I was ready for that. I replaced the tip right off. The filament I am using is new out of the sealed bag. Bed is leve...

So I’ve recently had an extruding problem which I seem to have finally overcome. I have now found however my prints are starting to warp after my around layer 3, I’m using a brim & the first few layers are fine before it starts to lift. I’m using hairspray (lots of it) on my super plate which origin...

Hi I'm new to 3d printing and have had my A10 for just over a week. At first everything was going great and prints were coming out fine, but lately they don't seem to be sticking on the 1st layer. free lightroom alternative The PLA starts to lay down its initial layer but starts to lift when its cha...